Florida General Knowledge practice test
50 questions · 80% to pass · Required for every CDL applicant.
How to use this practice test
Read each question, click an answer, and the correct choice is highlighted with a short explanation referencing the underlying CDL Manual concept. Your live score appears at the top of the page. Refresh to reset.
This test runs entirely in your browser. Nothing is uploaded; no account is required. Pages refresh to a new randomized cut from the bank.
-
1. What does the term "perception distance" mean?
Explanation. Perception distance is the distance traveled while your brain identifies a hazard, typically about 1.5 seconds at highway speed.
-
2. The eye-lead time recommended for highway driving is at least:
Explanation. Look 12-15 seconds ahead so you can identify hazards in time to react smoothly.
-
3. You should warm up the engine before driving because:
Explanation. Allowing the engine to warm circulates oil and reduces wear before load is applied.
-
4. According to the FMCSA CDL Manual, what does the term "perception distance" mean?
Explanation. Perception distance is the distance traveled while your brain identifies a hazard, typically about 1.5 seconds at highway speed. (Reinforcement variant — same underlying CDL Manual concept.)
-
5. When backing a commercial vehicle, you should:
Explanation. Backing toward the driver side gives the driver a direct line of sight, which is much safer than blind-side backing.
-
6. A driver loses their CDL for life if convicted of:
Explanation. Using a CMV to commit a controlled-substance felony is grounds for a lifetime CDL disqualification.
-
7. When taking the CDL knowledge exam, a safe following distance for a 40-foot vehicle at 50 mph is at least:
Explanation. Use 1 second per 10 feet of vehicle length under 40 mph, plus 1 extra second above 40 mph: 4 + 1 = 5 seconds for a 40-foot truck at 50 mph. (Reinforcement variant — same underlying CDL Manual concept.)
-
8. When taking the CDL knowledge exam, what does the term "perception distance" mean?
Explanation. Perception distance is the distance traveled while your brain identifies a hazard, typically about 1.5 seconds at highway speed. (Reinforcement variant — same underlying CDL Manual concept.)
-
9. When operating a CMV in interstate commerce, cargo should be inspected:
Explanation. You must inspect cargo within the first 50 miles, then every 150 miles or 3 hours, whichever is sooner. (Reinforcement variant — same underlying CDL Manual concept.)
-
10. When taking the CDL knowledge exam, carbon monoxide poisoning may be a hazard if:
Explanation. A cracked exhaust manifold or rusted-through pipe can leak CO into the cab, causing drowsiness or death. (Reinforcement variant — same underlying CDL Manual concept.)
-
11. Hours-of-service property-carrying drivers may drive a maximum of how many hours after 10 consecutive hours off duty?
Explanation. The federal HOS rule allows up to 11 hours of driving after 10 consecutive hours off duty.
-
12. When taking the CDL knowledge exam, hydroplaning is most likely when:
Explanation. Hydroplaning can occur at speeds as low as 30 mph if there is enough water and the tires cannot channel it away. (Reinforcement variant — same underlying CDL Manual concept.)
-
13. In real-world commercial driving, you should signal a lane change for at least:
Explanation. Signal early and continuously enough for surrounding traffic to see your intent. (Reinforcement variant — same underlying CDL Manual concept.)
-
14. When checking your vehicle, the engine should be off and the wheels chocked because:
Explanation. Chocking wheels and shutting down the engine prevents the vehicle from rolling away while you are underneath or alongside it.
-
15. When operating a CMV in interstate commerce, a driver may use a hand-held mobile phone while driving a CMV:
Explanation. Federal rules prohibit hand-held mobile phone use by CMV drivers except in emergencies. (Reinforcement variant — same underlying CDL Manual concept.)
-
16. When operating a CMV in interstate commerce, empty trucks need:
Explanation. Empty trucks have less traction and brakes designed for the loaded weight, so they can actually take longer to stop and lock up more easily. (Reinforcement variant — same underlying CDL Manual concept.)
-
17. In real-world commercial driving, hydroplaning is most likely when:
Explanation. Hydroplaning can occur at speeds as low as 30 mph if there is enough water and the tires cannot channel it away. (Reinforcement variant — same underlying CDL Manual concept.)
-
18. Most state DMV CDL handbooks state that when driving in fog, you should:
Explanation. High beams reflect off fog and reduce vision; low beams and slower speed are correct. (Reinforcement variant — same underlying CDL Manual concept.)
-
19. Hydroplaning is most likely when:
Explanation. Hydroplaning can occur at speeds as low as 30 mph if there is enough water and the tires cannot channel it away.
-
20. In real-world commercial driving, you should NOT drive when taking which of these?
Explanation. Drowsiness-causing medications, even legal ones, can disqualify you from driving. (Reinforcement variant — same underlying CDL Manual concept.)
-
21. According to the FMCSA CDL Manual, when checking your vehicle, the engine should be off and the wheels chocked because:
Explanation. Chocking wheels and shutting down the engine prevents the vehicle from rolling away while you are underneath or alongside it. (Reinforcement variant — same underlying CDL Manual concept.)
-
22. In real-world commercial driving, when driving in fog, you should:
Explanation. High beams reflect off fog and reduce vision; low beams and slower speed are correct. (Reinforcement variant — same underlying CDL Manual concept.)
-
23. According to the FMCSA CDL Manual, a retarder helps the driver by:
Explanation. Retarders slow the vehicle without using service brakes, reducing brake wear and overheating risk. (Reinforcement variant — same underlying CDL Manual concept.)
-
24. Per federal regulations, you should signal continuously when turning because:
Explanation. Continuous signaling keeps other drivers informed and prevents the signal from cancelling before the turn is complete. (Reinforcement variant — same underlying CDL Manual concept.)
-
25. During a pre-trip inspection, when you double your speed, your stopping distance:
Explanation. Stopping distance increases roughly with the square of speed, so doubling speed nearly quadruples the distance. (Reinforcement variant — same underlying CDL Manual concept.)
-
26. When operating a CMV in interstate commerce, retarders should usually be turned off when:
Explanation. On slick surfaces a retarder can cause drive wheels to skid; turn it off in those conditions. (Reinforcement variant — same underlying CDL Manual concept.)
-
27. When taking the CDL knowledge exam, convex (curved) mirrors:
Explanation. Convex mirrors widen the view but make objects appear smaller and farther away than they actually are. (Reinforcement variant — same underlying CDL Manual concept.)
-
28. Per federal regulations, when merging onto a highway, you should:
Explanation. Match traffic speed and yield; stopping is dangerous and can cause rear-end collisions. (Reinforcement variant — same underlying CDL Manual concept.)
-
29. Experienced commercial drivers know that when driving in the mountains, gravity will:
Explanation. Going downhill, gravity adds to your speed and the distance needed to stop. (Reinforcement variant — same underlying CDL Manual concept.)
-
30. According to the FMCSA CDL Manual, when checking lights during the pre-trip, you should turn the key on and:
Explanation. Have someone else watch, or turn lights on and off and walk around to verify each lamp is working. (Reinforcement variant — same underlying CDL Manual concept.)
-
31. When operating a CMV in interstate commerce, when checking your vehicle, the engine should be off and the wheels chocked because:
Explanation. Chocking wheels and shutting down the engine prevents the vehicle from rolling away while you are underneath or alongside it. (Reinforcement variant — same underlying CDL Manual concept.)
-
32. According to the FMCSA CDL Manual, stab braking is used:
Explanation. Stab braking is an emergency technique for non-ABS vehicles: brake hard until wheels lock, release, brake again. (Reinforcement variant — same underlying CDL Manual concept.)
-
33. Per federal regulations, carbon monoxide poisoning may be a hazard if:
Explanation. A cracked exhaust manifold or rusted-through pipe can leak CO into the cab, causing drowsiness or death. (Reinforcement variant — same underlying CDL Manual concept.)
-
34. When operating a CMV in interstate commerce, black ice is dangerous because:
Explanation. Black ice is a thin layer of ice clear enough that the road below shows through, making it look merely wet. (Reinforcement variant — same underlying CDL Manual concept.)
-
35. According to the FMCSA CDL Manual, a safe following distance for a 40-foot vehicle at 50 mph is at least:
Explanation. Use 1 second per 10 feet of vehicle length under 40 mph, plus 1 extra second above 40 mph: 4 + 1 = 5 seconds for a 40-foot truck at 50 mph. (Reinforcement variant — same underlying CDL Manual concept.)
-
36. Most pre-trip inspections begin with which step?
Explanation. The CDL Manual lists "review last inspection report" as the first step in the seven-step pre-trip inspection.
-
37. Convex (curved) mirrors:
Explanation. Convex mirrors widen the view but make objects appear smaller and farther away than they actually are.
-
38. Stab braking is used:
Explanation. Stab braking is an emergency technique for non-ABS vehicles: brake hard until wheels lock, release, brake again.
-
39. Drivers must complete a written post-trip inspection report when:
Explanation. Federal rules require a report whenever defects are found, and many carriers require one for every trip.
-
40. Most state DMV CDL handbooks state that you should signal continuously when turning because:
Explanation. Continuous signaling keeps other drivers informed and prevents the signal from cancelling before the turn is complete. (Reinforcement variant — same underlying CDL Manual concept.)
-
41. Aggressive driving by other motorists is best handled by:
Explanation. The safest response is to disengage and report when safe; never engage an aggressive driver.
-
42. Per federal regulations, when driving down a long, steep grade, you should:
Explanation. Always select a low gear before descending so engine compression helps hold speed and brakes do not overheat. (Reinforcement variant — same underlying CDL Manual concept.)
-
43. You should signal continuously when turning because:
Explanation. Continuous signaling keeps other drivers informed and prevents the signal from cancelling before the turn is complete.
-
44. When driving at night, you should adjust your speed so you can stop within:
Explanation. You must be able to stop within the distance you can see, which at night is the range of your low or high beam headlights.
-
45. When taking the CDL knowledge exam, you should warm up the engine before driving because:
Explanation. Allowing the engine to warm circulates oil and reduces wear before load is applied. (Reinforcement variant — same underlying CDL Manual concept.)
-
46. During a pre-trip inspection, you should check your mirrors:
Explanation. Frequent mirror checks (every 5-8 seconds) are part of safe scanning. (Reinforcement variant — same underlying CDL Manual concept.)
-
47. During a pre-trip inspection, what is the standard color of a placard for a Class 2 (gases) hazardous material?
Explanation. Class 2 placards are red for flammable gas, green for non-flammable, and yellow/white for poison/oxygen subdivisions. (Reinforcement variant — same underlying CDL Manual concept.)
-
48. You should signal a lane change for at least:
Explanation. Signal early and continuously enough for surrounding traffic to see your intent.
-
49. Most state DMV CDL handbooks state that when approaching a railroad crossing, you should:
Explanation. Always slow, look, listen, and prepare to stop. A full stop is required only for buses, hazmat, and certain placarded vehicles. (Reinforcement variant — same underlying CDL Manual concept.)
-
50. Most state DMV CDL handbooks state that brake fade is caused by:
Explanation. Brakes lose effectiveness when overheated; this is why low gears are essential on grades. (Reinforcement variant — same underlying CDL Manual concept.)
About the General Knowledge exam
The General Knowledge exam is required for every Class A, B, and C CDL applicant. It covers vehicle inspection, basic control, shifting, backing, communicating with other drivers, distracted driving, fatigue, hazard perception, emergency maneuvers, skid control, accident procedures, hazardous materials awareness, and federal hours-of-service rules.
This Florida-specific edition uses the same federal source material every U.S. state adopts. The Florida FLHSMV administers the actual exam at its service centers. Bring your CDL handbook for any last-minute reference; it’s free at every Florida FLHSMV office.
Once you’re consistently scoring above 90% on this practice set, you’re well above the 80% required to pass the official Florida exam. Drill the questions you miss most often, then take the test cold once a day for a week leading up to your appointment.
Tips that actually work
- Read every answer choice before clicking. CDL questions are famous for "best answer" wording where two choices look right.
- Don’t memorize question text — learn the underlying rule. The DMV reshuffles wording constantly.
- Keep a list of the questions you miss. Re-drill them in isolation until you can’t miss them.
- Practice in short, frequent sessions. Two 20-minute sessions per day beats one two-hour cram.
What happens after I pass?
Passing the knowledge test earns you a Commercial Learner’s Permit (CLP). You must hold the CLP for at least 14 days before you can take the road skills test, and you must drive with a CDL-holding instructor in the cab during that period. Once you pass the road skills test, your CDL is issued.